Normally when you go to mark bed as clear or ready all and are prompted with a spool that is going to be marked as empty but you want to adjust it before continuing, if you adjust it, it closes out of the mark bed as clear or ready all dialog after you adjust the spool. You then have to re-enter the dialog to continue.
This, in conjunction with the fact that from the mark all as clear doesn’t say which spool belongs to what printer, adds unnecessary clicks/ length to process.
If you were to simply make it so that you could adjust the spool, then once complete it just went back to the ‘mark all as clear’ or ‘mark bed as ready’ prompt it would streamline the process.